FAQ: How To Wire Under Kitchen Cabinet Lighting?
- 1 What kind of wire do you use for under cabinet lighting?
- 2 Is under counter lighting worth it?
- 3 How do you install hard wired under cabinet lighting?
- 4 Where do LED strips go under cabinets?
- 5 How do you connect LED strip lights to mains?
- 6 Can I use 18 gauge wire for LED lights?
- 7 Can speaker wire be used for LED lights?
- 8 Can you use thermostat wire for LED tape lights?
- 9 Do under cabinet lights go in front or back?
- 10 What are lights under cabinets called?
What kind of wire do you use for under cabinet lighting?
Although wire size ultimately depends on your light-fixture manufacturer’s specifications, 12-gauge wire is standard for most incandescent and fluorescent under-cabinet fixtures. A basic installation requires a 12-2 NM cable.
Is under counter lighting worth it?
Lower Your Energy Bill: Under cabinet lighting can actually save you money on your energy bill, and this is especially true if you opt for an LED light fixture. It has the potential to save money because you don’t have to illuminate the whole room just to get a little bit of light on the countertops below.
How do you install hard wired under cabinet lighting?
Then, follow these steps for installation:
- Disconnect the power. Locate the correct breaker and turn off the power supply to the switch outlet where you’re going to connect the lights.
- Attach the lights.
- Cut the wall.
- Run the wire.
- Run the cord.
- Connect the lights.
- Wire the switch.
- Cover your work.
Where do LED strips go under cabinets?
If you want to install under cabinet lighting as task lighting, you should place the strip lights closer to the middle front edge of the cabinets, so the countertop will be exposed to as much light as possible. For ambient or accent lighting, you may want to place them closer to the back edge.
How do you connect LED strip lights to mains?
How do I install my LED strip lighting? To get your strip light working, connect the transformer / driver to the strip light ( extending the cable with 2 core flex if necessary). Then you connect your transformer / driver to the mains via a plug or direct to the mains and you’re away.
Can I use 18 gauge wire for LED lights?
Most people would likely recommend using a solid core 18-gauge wire for your LED lights. The cost difference between this wire size and a much smaller cable is negligible, and 18-gauge is about as big as you can go if you would like your wires to fit into most holders or terminals.
Can speaker wire be used for LED lights?
Speaker wires, in general, can be used to wire LED light setups fairly well since LED lights are fairly low voltage. However, you still need to choose speaker wire that’s the right gauge for the LED setup that you want to put together.
Can you use thermostat wire for LED tape lights?
With 40′ of cable, you’d be right about at the limit when drawing 4A, allowing for some additional voltage drop through the strip itself. Consider dividing the 15′ strips into smaller sections and running a separate power cable to each one. Thermostat wire should be fine.
Do under cabinet lights go in front or back?
Tips for Installing Under-Cabinet Lighting When mounting any fixture under a cabinet, position it to the front. If there is a lens, face it toward the backsplash. The bottom-front rail of the cabinet should hide the fixture from your line of sight, whether you’re standing or seated.
What are lights under cabinets called?
Whether it’s in the kitchen, office, or over a craft table, sometimes your work space needs more light. Under cabinet lights, also known as countertop lights, have been around for a long time, but with new options becoming available the trend has gained a new life.