Quick Answer: How To Adjust Blum Kitchen Cabinet Hinges?

Can soft close hinges be adjusted?

Take a moment to focus on the soft close hinge and find the adjustment tab. Look for gray or silver plunger in the center of the hinge. To confirm that it’s the adjustment tab, try pulling on it with the tip of your finger.

What is a Blum hinge?

The hinge we use at Cabinets Quick is the Blum, a soft closing hinge that has a little switch to turn on and off the soft close function. This is called an inserta hinge and is useful when putting in on a door. This causes many complications down the road when the door needs to be put back on.

Where do you drill holes for Blum hinges?

1. To locate center of hinge cup on back side of door, measure over from edge of door 22.5mm (7/8 ). Here drill a 35mm (13ΒΌ8 ) diameter by 13mm (1/2 ) deep hole.

Are Blum hinges any good?

The hinges are highly adjustable, so getting good alignment between doors and door and cabinet is pretty easy. The soft-close damper can be turned off on individual hinges, so smaller, lighter doors need only one damper per door for good operation. The online instructions from Blum are excellent.

How do you adjust soft close cabinet hinges that won’t close?

Use a screwdriver to turn them both clockwise one-quarter turn at a time to add tension to the internal spring. Test the door. If it still won’t close, turn the adjusting screws one-quarter turn at a time until the door closes and stays closed. Open the door and let go of it, or push it slightly.

You might be interested:  How To Create An Electrical Series For Lights Under Kitchen Cabinet?

How do I make my cabinets soft close?

Can You Convert Cabinets to Soft Close

  1. To get a soft close mechanism for your cabinets, you do not have to do a complete hinge replacement.
  2. You can get a conversion kit to do your soft close.
  3. While you do not necessarily have to replace the hinges, if you want to do so, then it is best to choose a soft close hinge.

Leave a Reply

Your email address will not be published. Required fields are marked *